Flomec G2 - Specifications: ANSI Flange Fittings

14
SPECIFICATIONS – ANSI FLANGE FITTINGS
All data on Model 1 inch determined with 1 centipoise solvent test fluid at 70° F (21°
C). Data on Models 1-1/2 inch and 2 inch is determined with water at 70° F (21° C).
Model Size
S10F
1 in.
S15F
1
‑
‑‑
‑
1/2 in.
S20F
2 in.
Linear Flow Range
Gallons/minute (GPM) 5-50 10-100 20-200
Litres/minute (LPM) 18.9-190 38-380 76-760
Maximum Flow
1
Gallons/minute (GPM) 75 150 300
Litres/minute (LPM) 284 568 1,136
Maximum Pressure Drop
in 10:1 Range
PSIG 10 4 7
bar 0.69 0.28 0.48
Frequency Range in
Linear Flow Range
47-470 Hz 36-360 Hz 33-330 Hz
Connections
ANSI 150 lb. Flange Yes Yes Yes
Bolt Size 1/2 in. 1/2 in. 5/8 in.
Weight*
Pounds 5.7 lbs. 10.2 lbs. 16.7 lbs.
Kilograms 2.6 kg 4.6 kg 7.6 kg
* Computer electronics add 0.2 lbs. (0.1kg) to total weight.
1
The meter can operate up to this flowrate without damage. Continuous
operation will severely degrade meter life and performance.
Performance
Linear Range for 1 in.: 10:1 @ ±1.5% of reading
Linear Range for 1-1/2 in. and 2 in.: 10:1 @ ±1.0% of reading
Repeatability: ±0.1%
Pressure Rating Flange Rule
Wetted Components
Housing: 316 Stainless Steel
Journal Bearings: Ceramic (96% Alumina)
Shaft: Tungsten Carbide
Rotor and Supports: PVDF
Retaining Rings: 316 Stainless Steel
Temperature Range -40° F to +250° F (-40° C to +121° C)
These temperatures apply to operations and storage. They are only for the
turbine without computer electronics. Final operational temperature range is
determined by computer electronics or accessory modules.