27 GB/IE
When inserting ensure the correct
polarity! This is shown inside the
battery compartment!
Clean the contacts on the battery
and in the battery compartment
before inserting!
Remove exhausted batteries /
rechargeable batteries from the
product immediately.
Before use
Remove all packaging material.
Inserting / replacing batteries
(Transmitter)
Ensure that the product is switched off before
inserting / replacing the batteries.
Remove the hook-and-loop fastener
21
behind the
battery compartment cover
20
.
Open the battery compartment cover
20
by push-
ing the slide fastener in the direction of the arrow.
Insert two 1.5 V AAA batteries into the battery
compartment
18
. Ensure correct polarity (+ and -).
This is indicated on the inside of the battery com-
partment
18
.
Reattach the battery compartment cover
20
to the
battery compartment
18
. Please note that it will
click audibly.
Inserting / replacing batteries
(Receiver)
Ensure that the product is switched off before
inserting / replacing the batteries.
Place the receiver
1
on its front and remove the
fastening clip
9
by sliding it to the left.
Slide the battery compartment cover
8
off while
pressing down on it gently.
Insert two 1.5 V AAA batteries into the battery
compartment
10
. Ensure correct polarity (+ and -).
This is indicated on the inside of the battery com-
partment
10
.
Place the battery compartment cover
8
back onto
the battery compartment
10
and insert the fasten-
ing clip
9
by sliding it into the bracket until it
snaps into place.
Connecting the temperature
sensor
Insert the connector
15
of the temperature sensor
14
into the socket
16
on the side of the transmit-
ter
13
. The temperature sensor
14
may be kept
in the holder above the transmitter
13
.
To Next Page
Loading...