Byron Jackson H2O+ User Instruction – LM028843 EN
Page 4 of 54
1 General Information
1.1 Scope of manual
These instructions must be kept close to the product’s operating location or directly with the
product.
These instructions must be read prior to installing, operating, using, or maintaining the equipment
in any region worldwide. The equipment must not be put into service until all the safe operating
conditions noted in the instructions have been met. Failure to comply with the information provided
in the User Instructions is considered misuse. Personal injury, product damage, delay in operation, or
product failure caused by misuse are not covered by the Flowserve warranty.
Flowserve products are designed, developed and manufactured with state-of-the-art technologies
in modern facilities. The unit is produced with great care and commitment to continuous quality
control, utilizing sophisticated quality techniques, and safety requirements.
Flowserve is committed to continuous quality improvement and being of service for any further
information about the product with its installation and operation or about its support products, repair
and diagnostic services.
Byron Jackson H2O+ Submersible Pumps and Motors (water-filled)
These instructions are intended to familiarize the reader with the product and its permitted use.
Operating the product in compliance with these instructions is important to help ensure reliability in
service and avoid risks. These instructions may not reflect all local regulations; ensure all local
regulations are observed by all, including those installing the product. Always coordinate repair
activities with operations personnel and follow all plant safety requirements and applicable safety
and health legislation.
1.2 Disclaimer
Information in this User Instruction is believed to be complete and reliable. Despite all Flowserve’s
efforts to provide comprehensive information and instructions, sound engineering and safety
practices should always be used. Please consult with a qualified engineer.
Flowserve manufactures products to applicable International Quality Management System Standards
as certified and audited by external Quality Assurance organizations. Genuine parts and accessories
have been designed, tested, and incorporated into the products to help ensure continued product
quality and performance in use. As Flowserve cannot test parts and accessories sourced from other
vendors, the incorrect incorporation of such parts and accessories may adversely affect the
performance and safety features of the product. The failure to properly select, install, or use authorized
Flowserve parts and accessories is considered misuse. Damage or failure caused by misuse is not
To Next Page
Loading...
