Name: Flowserve IPS Detect
Brand: Flowserve
Rating: 5 (1 reviews)

To Next Page

To Previous Page

IPS Detect

Page 16 of 35

OIM_FLS_IPS Detect_EN_14

Subject to technical changes! FLOWSERVE

5.2.1.2 Deactivating the condition monitoring mode with the push-button

1. Loosen the screws and remove housing-cover and gasket. Depress the push-

2. Release the push-button until the green and yell

3. After approximately 1 minute the sensor will change to measuring mode and any

existing calibration data is deleted.

The condition monitoring is then deactivated.

Questions and Answers:

Need help?

Do you have a question about the Flowserve IPS Detect and is the answer not in the manual?

Flowserve IPS Detect Specifications

General