Flowserve Logix 3200IQ - Page 3

3
Logix 3200IQ Digital Positioner FCD LGENTB0058-03 – 01/11
flowserve.com
The Flowserve
®
Logix™ 3200IQ high-performance digital HART
®
positioners utilize state-of-the-art piezo technology to provide
superior performance and reliability. This is accomplished through
the use of a powerful 32-bit microprocessor and a proprietary two-
stage electronic relay. Among the Logix 3200IQ’s more attractive
features are the on-board QUICK-CAL™ button, DIP switches,
Jog buttons, and variable gain selector. These features allow the
user to complete setup and calibration of either diaphragm- or
piston-operated valves in a couple of minutes, without the need of
additional handheld devices or software.
The Logix 3200IQ offers valve status updates at a glance using
the highly visible LEDs. Users can easily determine if a valve or
actuator is functioning properly, and quickly diagnose any problems
using the 36 smart LED blink codes. This means that maintenance
personnel can provide a visual check of the valve status without
having to remove the cover or connect a HART hand-held device or
maintenance PC/laptop.
Data transfer with SoftTools™ software is substantially faster
than other current HART-compatible systems, resulting in a
dramatic speed increase in configuration and diagnostic signature
acquisition. The Logix 3200IQ communicates using the latest HART
communications protocol, which provides additional capabilities
(including burst mode) over previous versions of HART.
Superior Performance and Reliability
Introducing the Flowserve Logix™ 3200IQ Digital Positioner
All Blink
Codes Listed
Large QUICK-CAL
Button
Jog
Buttons
DIP Switches for
Fast and Easy Setup
Gain Selector
Switch
No Exposed
Electronics
Inside the Logix 3200MD
Figure 1 – Logix 3200MD Controls