ROTADISK Pneumatic Actuator RD & RDF
Operating Manual – BA3002 EN
6 Commissioning
Page 39 of 79
6 Commissioning
6.1 Safety Information
To avoid personal injury and/or material damage, make sure that
commissioning, flushing and pressure testing work is performed only by
qualified personnel with suitable personal protective equipment (PPE) and
suitable tools.
See chapter 2 Safety Information.
Danger of injury due to failure to observe plant-specific regulations!
Failure to observe plant-specific regulations can cause severe injuries or
even death.
Observe plant-specific regulations.
Observe safety information in section 2.1.
Danger of material damage due to control medium!
A wrong control medium or too high control pressure (> 8 bar) can cause material
damage to the ROTADISK Pneumatic Actuator.
Use only a gaseous control medium (usually compressed air or neutral gases such as
𝑁
2
, 𝐶𝑂
2
.
Pressurise the ROTADISK Pneumatic Actuator with maximum 8 bar control pressure.
To Next Page
Loading...
