flsun QQ-S - Page 6

6.Connection bus section
7.Install the side shell and bracket
8.Tighten the screws
5.Connection limit switch and Titan extruder
Tighten axis fixing screws
of upper shell
Tighten axis fixing screws
of bottom shell
Untie the wire
Connect the set of
connectors
Connect others in the
same way
Install the Titan extruder
Connect airline
Put side shell from top
then insert to bottom shell
Tighten fixing screw of
the side shell
Filament holder mounted
on the upper shell
Complete the assembly
Tighten the nut
Connecting extruder
motor line
Connect feed tube
7
8