HF110PEN_v0501_04
Page 6
Configuration of the unit
The F110-P was designed to be implemented in many types of applications. For that reason, a
SETUP-level is available to configure your F110-P according to your specific requirements.
SETUP includes several important features, such as K-factors, measurement units, signal selection
etc. All setting are stored in EEPROM memory and will not be lost in the event of power failure or a
drained battery.
To extend the battery-life time (option), please make use of the power-management functions as
described in chapter 3.2.3.
Display information
The unit has a large transflective LCD with all kinds of symbols and digits to display measuring units,
status information, trend-indication and key-word messages.
Flowrate and totals can be displayed either with the small 8mm digits or with the 17mm digits.
A backup of the total and accumulated total in EEPROM memory is made every minute.
Options
The following options are available: isolated or active 4-20mA / 0-10V / 0-20mA analog output, full
Modbus communication RS232/485/TTL (also battery powered), intrinsic safety, mechanical relay or
active output, power- and sensor-supply options, panel-mount, wall-mount and weather-proof
enclosures, flame proof enclosure and LED backlight.
To Next Page
Loading...
