110 PLUS and 115
Users Manual
16
The Meter measures the frequency of a signal by counting the
number of times the signal crosses a trigger level each second.
The trigger level is 0 V, 0 A for all ranges.
Press to turn the frequency measurement function on and
off. Frequency works with ac functions only.
In frequency, the bar graph and range annunciator indicate the
ac voltage or current present.
Select progressively lower ranges using manual ranging for a
stable reading.
Low Impedance Capacitance Measurements
(115 only)
For making capacitance measurements on cables with ghost
voltage, hold while turning on the Meter to switch the
Meter into LoZ, (low input impedance) Capacitance mode. In
this mode, capacitance measurements will have a lower
accuracy and lower dynamic range. This setting is not saved
when the Meter is turned off or goes into sleep mode.
Testing Diodes (115 only)
Forward Bias
Single
Beep
Reverse Bias
Shorted
and
Open
Bad Diode Bad Diode
Good Diode Good Diode
edy07f.eps
To Next Page
Loading...
