1
Getting Started
Introduction
This Getting Started Manual provides basic information
on the Fluke 125 ScopeMeter Test Tool. For complete
operating instructions, refer to the Users Manual on the
accompanying CD-ROM
Contacting a Service Center
To locate a Fluke authorized service center, visit us on
the World Wide Web at: www.fluke.com
or call Fluke using any of the phone numbers listed
below:
+1-888-993-5853 in the U.S.A and Canada
+31-40-2675200 in Europe
+1-425-446-5500 from other countries.
Safety Information: Read First
The Fluke 125 ScopeMeter Test Tool (hereafter referred
to as “Test Tool”) complies with:
• ANSI/ISA-82.02.01
• EN/IEC 61010-1: 2001 600 V Measurement
Category III, Pollution Degree 2
• CAN/CSA-C22.2 No.61010-1-04 (including
C
CSA
US
approval)
Use the Test Tool only as specified in the Users Manual.
Otherwise, the protection provided by the Test Tool might
be impaired.
A Warning identifies conditions and actions that pose
hazard(s) to the user. A Caution identifies conditions and
actions that may damage the Test Tool.
To Next Page
Loading...
Need help?
General
