Getting Started
Displaying an Unknown Signal with Connect-and-View™ (Auto Set)
7
Displaying an Unknown Signal with
Connect-and-View™ (Auto Set)
The Connect-and-View™ function enables hands-off
operation to display complex unknown signals in
SCOPE/METER mode. This function optimizes the
position, range, time base, and triggering and assures a
stable display on nearly all waveforms. If the signal
changes, the setup will track these changes.
To enable the Connect-and-View™ function, do the
following:
• Connect the red test lead from red Input A to the
unknown signal to be measured
Perform an Auto Set.
Certain details of the waveform can be made visible by
manually changing amplitude, time base, waveform
position, and triggering. How to do that is explained in the
course of this Guide.
Freezing the Screen
You can freeze the screen (Waveforms and Readings)
with the HOLD/RUN key. This allows you read the screen
while the Test Tool has been disconnected from the
Device to be checked.
Freeze the screen. HOLD appears in
the bottom of the reading screen.
Start the measurement again.
Scope/Meter Measurements
Make the input connections as described on page 6.
Selecting the SCOPE/METER mode
Open the application mode menu.
Highlight SCOPE/METER
Enter the SCOPE/METER mode.
To Next Page
Loading...
