Fluke 287 - Symbols

True-rms Digital Multimeters
Symbols
3
Symbols
Table 1 lists and describes the symbols appearing on the Meter and in this manual.
Table 1. Symbols
Symbol Description Symbol Description
B
AC (Alternating Current or Voltage)
I
Fuse
F
DC (Direct Current or Voltage)
T
Double Insulated
X
Hazardous voltage
W
Important Information; refer to manual
E
Battery (Low battery when shown on the display)
J
Earth ground
R Continuity test or continuity beeper tone
$
Conforms to relevant Canadian and US standards
P
Conforms to European Union directives
;
N10140
Conforms to relevant Australian standards
t
Underwriters Laboratory listed product.
s
Inspected and licensed by TÜV Product Services
CAT III
IEC Measurement Category III – CAT III equipment is
designed to protect against transients in equipment
in fixed equipment installations, such as distribution
panels, feeders and short branch circuits, and
lighting systems in large buildings.
CAT IV
IEC Measurement Category IV – CAT IV equipment is
designed to protect against transients from the
primary supply level, such as an electricity meter or an
overhead or underground utility service.
~
Do not dispose of this product as unsorted municipal waste. Go to Fluke’s website for recycling information.