Fluke 289 Getting Started

287/289
Getting Started
2
• Remove test leads from the Meter before opening the
battery door.
• Inspect the test leads for damaged insulation or
exposed metal. Check the test leads for continuity.
Replace damaged test leads before you use the Meter.
• Do not apply more than the rated voltage, as marked
on the Meter, between the terminals or between any
terminal and earth ground.
• Never operate the Meter with the cover removed or the
case open.
• Use caution when working with voltages above 30 V ac
rms, 42 V ac peak, or 60 V dc. These voltages pose a
shock hazard.
• Use only the replacement fuses specified by the
manual.
• Use the proper terminals, function, and range for
measurements.
• Avoid working alone.
• When measuring current, turn off circuit power before
connecting the Meter in the circuit. Remember to
place the Meter in series with the circuit.
• When making electrical connections, connect the
common test lead before connecting the live test lead;
when disconnecting, disconnect the live test lead
before disconnecting the common test lead.
• Do not use the Meter if it operates abnormally.
Protection may be impaired. When in doubt, have the
Meter serviced.
• Do not operate the Meter around explosive gas, vapor,
or dust.
• Use only 1.5 V AA batteries, properly installed in the
Meter case, to power the Meter.
• When servicing the Meter, use only specified
replacement parts.
• When using probes, keep fingers behind the finger
guards on the probes.
• Do not use the Low Pass Filter option to verify the
presence of hazardous voltages. Voltages greater than
what is indicated may be present. First, make a
voltage measurement without the filter to detect the
possible presence of hazardous voltage. Then select
the filter function.
• Only use test leads that have the same voltage,
category, and amperage ratings as the meter and that
have been approved by a safety agency.
• Use proper protective equipment, as required by local
or national authorities when working in hazardous
areas.
• Comply with local and national safety requirements
when working in hazardous locations.

Fluke 289 Specifications

General

Product type	Analog multimeter
AC current range	5 - 10 A
Continuity check	Yes
DC voltage range	5 - 1000 V
Resistance range	50 - 500 Ω
Capacitance range	1 - 100 nF
Resolution (frequency)	999.99 Hz
Resolution (AC current)	5000 µA
Resolution (DC voltage)	500 mV
Temperature measurement range	-20 - 55 °C
Dimensions (WxDxH)	10.2 x 6 x 22.2 mm
Battery voltage	1000 V

Weight and Dimensions

Weight	870.9 g