1
Introduction
XWWarning
Read “Safety Information” before using this Meter
Except where noted, the descriptions and instructions in this manual
apply to both the Fluke 287 and 289 True-rms Digital Multimeters
(hereafter referred to as “the Meter”). Model 289 appears in all
illustrations.
This manual covers information for turning on the Meter, understanding
its controls, and basic maintenance. For complete operational
instructions, refer to the 287/289 Users Manual contained on the
accompanying CD.
Contacting Fluke
To contact Fluke, call one of the following telephone numbers:
USA: 1-888-993-5853
Canada : 1-800-363-5853
Europe : +31 402-675-200
Japan: +81-3-3434-0181
Singapore : +65-738-5655
Anywhere in the world: +1-425-446-5500
Visit Fluke's web site at: www.fluke.com
Register your Meter at: register.fluke.com
Safety Information
The Meter complies with:
• ANSI/ISA 82.02.01 (61010-1) 2004
• UL 61010B (2003)
• CAN/CSA-C22.2 No. 61010-1-04
• IEC/EN 61010-1 2
nd
Edition Pollution Degree 2
• EMC EN 61326-1
• Measurement Category III, 1000V, Pollution Degree 2
• Measurement Category IV, 600 V, Pollution Degree 2
In this manual, a Warning identifies hazardous conditions and actions
that could cause bodily harm or death. A Caution identifies conditions
and actions that could damage the Meter, the equipment under test, or
cause permanent loss of data.
Symbols used on the Meter and in this manual are explained in Table 1.
XWWarning
To avoid possible electric shock or personal injury, follow
these guidelines:
• Use this Meter only as specified in this manual or the
protection provided by the Meter might be impaired.
• Do not use the Meter if it is damaged. Before you use
the Meter, inspect the case. Look for cracks or
missing plastic. Pay particular attention to the
insulation surrounding the connectors.
• Make sure the battery door is closed and latched
before operating the Meter.
To Next Page
Loading...
