345
Calibration Manual
10
Battery Charger/Power Adapter
Note
To accommodate connection to various line power sockets, the BE345
Universal Battery Eliminator is equipped with a male plug that must be
connected to a line plug adapter appropriate for local use.
Since the Charger is isolated, you can use line plug adapters with or
without a protective ground terminal. The 230 V rating of the BE345 is not
for use in North America. A line plug adapter complying with the
applicable country-specific requirements may be provided to alter the blade
configuration.
The Clamp Meter can be used with an included ac power adapter.
XWWarning
To avoid possible electric shock or personal injury, follow these
guidelines:
• To supply ac power, only use the BE345 Universal Battery
Eliminator.
• Before use, check that the selected voltage range indicated
on the BE345 matches the local line power voltage and
frequency (refer to Figure 2). If necessary, set the slider
switch of the BE345 to the correct voltage.
• For the BE345, use only ac line plug adapters or ac line
cords that comply with local safety regulations.
115V 230V
fcs 002.eps
Figure 2. Slider Switch for Line Power Voltage (115 V and 230 V)
To Next Page
Loading...
