345
Calibration Manual
12
fcs005.eps
Figure 3. Changing the Batteries
Verification Tests
The following tests verify the functions of the Clamp Meter. If any of the verification
tests fail, repair is necessary. For service, see Contacting Fluke.
Battery and Battery Eliminator Check
With six new AA batteries installed, the battery symbol next to the date on the display
should show a indicate full batteries.
1. Connect the BE345 Battery Eliminator. The battery symbol on the display changes to
a plug symbol
.
2. Disconnect the Battery Eliminator. The
should change back to a.
To Next Page
Loading...
