53 & 54 Series II
Users Manual
10
Changing the Logging Interval
The logging interval determines how often the
thermometer stores logged readings in memory. You
choose the length of the logging interval. See "Using
Memory."
The thermometer stores logged readings at the end of
each logging interval. You can select a logging interval of
1 second (1), 10 seconds (2), 1 minute (3), 10 minutes (4),
or user-defined (
USef).
You can also set the logging interval manually (0). Each
time you press
J, the thermometer stores the current
readings in memory.
1. Press K or N until the display shows INTERVAL.
2. Press
E to display the logging interval choices.
3. Press
K or N until the display shows the logging
interval you want, and then press
E to select.
4. If you selected a user-defined logging interval:
• Press K or N until the display shows
hour:min or min:sec, and then press
E to
select.
The left two digits blink.
• Press
K or N until the left two digits you want
appear on the display, and then press
E to
select them.
The right two digits blink.
• Press
K or N until the right two digits you
want appear on the display, and then press
E
to select them.
Holding down
K or N causes the number to
change more quickly.
To Next Page
Loading...
Need help?
General
