Fluke 5502E - Page 12

5502E
Getting Started
2
0
•
123
4
5
6
7
8 9
ENTER
M
k
m
V Hz
/
+
F
OPR
STBY
EARTH
TRIG
OUT
SCOPE
ME
NU
PREV
SHIFT
RESET
CE
SETUP
REF
NEW
TC
MEAS
¡F
n
p
W
dBm
sec
¡C
POWER
A
MULT
x
DIV
CAL
ZERO
FIELD
EDIT
5502E
CALIBRATOR
gvw001.eps
Figure 1. 5502E Multi-Product Calibrator
Calibrator features include:
• Automatic meter error calculation, with reference values that you can select.
•  and  keys that change the output value to predetermined values for various
functions.
• Programmable entry limits. These limits do not let you go above preset output limits.
• Voltage and current that can be output at the same time, to an equivalent of 20.9 kW.
• The power to output two voltages at the same time.
• Extended bandwidth mode outputs multiple waveforms down to 0.01 Hz, and sine
waves to 2 MHz.
• A Standard IEEE-488 (GPIB) interface that complies with ANSI/IEEE Standards
488.1-1987 and 488.2-1987.
• A EIA Standard RS-232 serial data interface to print, show, or move internally stored
calibration constants, and for remote control of the 5502E.
• A pass-through RS-232 serial data interface to send data to the Unit Under Test
(UUT).