5502E
Getting Started
4
This Calibrator complies with:
• ANSI/ISA-61010-1 (82.02.01)
• CAN/CSA C22.2 No. 61010-1-04
• ANSI/UL 61010-1:2004
• EN 61010-1:2001
• ANSI/IEEE Standards 488.1-1987 and 488.2-1987.
Symbols used in this manual and on the Product are in Table 1.
Table 1. Symbols
Symbol Description Symbol Description
CAT I
IEC Measurement Category I – CAT I
is for measurements not directly
connected to mains. Maximum
transient Overvoltage is as specified
by terminal markings.
Conforms to relevant North American
Safety Standards.
Conforms to European Union
directives.
This product complies with the WEEE
Directive (2002/96/EC) marking
requirements. The affixed label indicates
that you must not discard this
electrical/electronic product in domestic
household waste. Product Category: With
reference to the equipment types in the
WEEE Directive Annex I, this product is
classed as category 9 "Monitoring and
Control Instrumentation” product. Do not
dispose of this product as unsorted
municipal waste. Go to Fluke’s website for
recycling information.
Risk of Danger. Important
information. See manual.
Hazardous voltage
Earth ground
Conforms to relevant Australian EMC
requirements.
To Next Page
Loading...
