5700A/5720A Series II Calibrator
Service Manual
4-16
230 5725 RESET (power-up or watchdog timer)
231 5725 Guard-Crossing Timeout
232 5725 Illegal/Unexecutable Command
233 5725 Non-Maskable Interrupt Occurred
234 5725 HVCLEAR Circuit Activated
235 Output Tripped To Standby
400-Level Faults: Calibration Constant Subsystem
400 Bad Cal Constant ID
500-Level Faults: Configuration Finder Subsystem
500 Bad Mode To CNFmodeRanges
501 Configuration Table Overflow
502 Bad Amplifier Type Selection
503 Bad Flat Constant Type Selection
504 Bad Flat Constant Type In Table
505 5725 Guard Crossing Wouldn't Start
600-Level Faults: Dot Matrix Display Driver Subsystem
600 Bad Row Selector
601 Bad Column Argument
602 Bad Character
800-Level Faults: Executive Subsystem
800 Wideband Module Needed
801 Amplifier Not Selected Or Connected
802 Amplifier Must Remain On For This Output
803 Over Limits Of Locked Range
804 Under Limits Of Locked Range
806 Invalid Date
807 Invalid Time
808 DC dBm Not Allowed
809 Ext Ref Value Out Of Range
810 Bad Edit Digit Movement
811 Not Wideband Units
812 Cannot Set Frequency With Ohms
813 Bad Units
814 Wrong Polarity For Limit
To Next Page
Loading...
