Documenting Process Calibrator
Setting Up the Calibrator
25
Proceed as follows to set up the time and date
displays:
1. Press s.
2. Press the
Next Page softkey. The display
appears as follows:
gj38s.eps
3. Use the u and d keys to move the cursor to
the parameter you want to change, then press
eor the
Choices softkey to choose a
setting for that parameter. For example, the
following display appears after you select
Date
Format
:
gj39s.eps
4. Press uor d to move the cursor to the desired
date format.
5. Press eto go back to the sdisplay.
6. Make another selection or press the
Done
softkey or s to save your settings and exit
Setup mode.
To Next Page
Loading...
