Documenting Process Calibrator
Using Measure Mode
39
TC
mA mA
V
RTD
RTD
SOURCE
30V
MAX
30V
MAX
30V
MAX
MEAS
CAT
V
300V
MAX
OK
V
RTD
MEASSOURCE
mA mA
RTD
V
300V
MAX
30V MAX
TC
V
RTD
MEASSOURCE
mA mA
RTD
V
300V
MAX
30V MAX
TC
WRONG
gj14f.eps
Figure 14. Using a Jumper Correctly
8. If necessary, you can change between °C or °F
temperature units in Setup mode as follows:
a. Press s.
b. Press the
Next Page softkey twice.
c. Use the u and d keys to move the cursor
to the parameter you which to change, then
press e or the
Choices softkey to
choose a setting for that parameter.
d. Press u or d to move the cursor to the
desired setting.
e. Press eto go back to the sdisplay.
f. Press the
Done softkey or s to exit Setup
mode.
9. If necessary, you can change between
ITS-90 or
IPTS-68 Temperature Scale in Setup mode. The
procedure is the same as steps a through f
above.
To Next Page
Loading...
