Fluke 772 - Symbols; Specifications; Electrical Specifications

772/773
Calibration Manual
4
Symbols
Table 1 refers to the symbols that are on the Meter or in this manual.
Table 1. Symbols
- Do not apply around, or remove from HAZARDOUS LIVE conductors.
W Dangerous. Important data. See Users Manual.
X Risk of Electrical Shock.
T Equipment protected by double or reinforced insulation.
M Battery
B Low Battery
P Confirms with relevant European Union directives.
F DC (Direct Current)
~
Do not dispose of this the product as unsorted municipal waste. Go to Fluke’s web site for
recycling data.
; Conforms to relevant Australian standards.
) Conforms to relevant Canadian and US standards.
Specifications
Electrical Specifications
DC Current Measurement
With Jaw
Ranges ......................................0-20.99 mA; 21-100 mA
Resolution.................................. 0.01 mA; 0.1 mA
Accuracy....................................0.2 % + 5 counts; 1 % + 5 counts
In Circuit
Range........................................ 0-24 mA
Resolution.................................. 0.01 mA
Accuracy....................................0.2 % + 2 counts
Current Source
Range........................................ 0-24 mA
Resolution.................................. 0.01 mA
Accuracy....................................0.2 % + 2 counts
mA Drive.................................... 24 mA into 1000 Ω
Current Simulate
Range........................................ 0-24 mA
Resolution.................................. 0.01 mA
Accuracy....................................0.2 % + 2 counts
Maximum Voltage...................... 50 V
DC Voltage Measurement (773)
Range........................................ 0-30 V
Resolution.................................. 0.01 V
Accuracy....................................0.2 % + 2 counts