80i-110s Instruction Manual 11
INSTRUMENT COMPATIBILITY
The 80i-110s is compatible with any Fluke ScopeMeter test tool, Power Harmonics
Analyzer, Oscilloscope, Multimeter, or other voltage measurement device that has
the following features:
•
BNC input connector. A BNC-to-banana adapter (order PM9081/001 from
Fluke) can also be used with standard inputs on a digital multimeter (DMM).
•
Input accuracy of 2% or better to take full advantage of the accuracy of the probe.
•
Input impedance of greater than or equal to 1 M
:
in parallel with a maximum
of 100 pF.
•
A passband of more than four times the frequency of the waveform to be
measured.
To Next Page
Loading...
