80i-110s Instruction Manual 5
INSTALLING THE BATTERY
WARNING
TO AVOID ELECTRICAL SHOCK, UNCLAMP THE CURRENT PROBE FROM
ANY CONDUCTOR, AND DISCONNECT THE SCOPEMETER TEST TOOL OR
ANY OTHER MEASUREMENT DEVICE BEFORE INSTALLING OR REPLACING
THE BATTERY.
At first use, remember to install the battery. Referring to Figure 2, use the following
procedure to install the battery:
1. Be sure that you have unclamped the Current Probe from any conductor and
have disconnected the ScopeMeter test tool or any other measurement device.
2. Be sure that the Current Probe is in the OFF position.
3. Locate the battery cover on the handle. (see Figure 2.) Loosen the screw with
a flat-blade screwdriver.
4. Slide the battery cover away from the Current Probe.
5. Install the battery (IEC 6LR61) as shown in Figure 2. Arrange the battery leads
so that they will not be pinched between the handle bottom and the battery cover.
6. Reinstall the battery cover and secure the screw.
Figure 2. Installing the Battery
To Next Page
Loading...
