810
Getting Started
16
Instrument Setup
Push # or the Instrument Setup softkey to display
the Self test, Settings, and Clear memory options.
gbk25.bmp
Use the Dial to highlight an option. Push the Dial or Enter
(F3) softkey to select that option.
Self Test
The Self test option tests the internal modules of the
Tester. When you select the Self test option, the Tester
runs a test module and then displays the self test results
as pass or fail.
gbk26.bmp
Push the Done softkey to go back to Instrument Setup.
Note
If the self-test fails, contact Fluke Service.
To Next Page
Loading...
