Fluke 867B - Measuring Ohms, Continuity, and Conductance

Making Measurements
Measuring Ohms, Continuity, and Conductance
2
2-9
ACOM
V
EXT TRIG
1
4
3
FREEZE
DISPLAY
MODE
SAVE
PRIN T
MIN
MAX
RANGE
WAKE UP
HZ
TOUCH
HOLD
12 5
3 4
Red
2
mA/
A
rita0580.eps
Figure 2-4. Ohms, Continuity, and Conductance
Measurements
Measuring Ohms, Continuity, and
Conductance
6
Turn the Selector to Ohms. Softkeys for
Meter and Trend Modes appear
momentarily. Wait briefly to accept Meter
Mode, or press
4
to select Trend Mode.
7
Connect the test leads as shown.
8
Use the Ohms (Meter or Trend Mode)
Softkeys as discussed below.
9
F
is not available in Ohms; all other
hardkeys can be used.
At any time, press
d
and one of the softkeys
(Combo, Meter, View, or Trend) to show the
measurement in a different display mode.