Fluke 867B - Printing

867B/863
Users Manual
6-6
Printing
Print
Stop
Print
NOTE
Do not print if the GMM is presently
controlled by FlukeView 860 application
software.
Use the following procedure for printing:
1. Verify appropriate “Printer Type”, “Baud Rate”,
and “Parity”. These selections appear as the last
three items on the SET UP screen (selector
turned to SET UP.)
2. Connect the GMM to a printer as shown in
Figure 6-2. Or, download the screen to
FlukeView 860 Application Software running on
a PC. Then print from FlukeView 860.
3. Set the GMM to display the screen you want to
print. The screen can be the active display or
one of the recalled screens.
4. Press
3
(Print) to begin printing.
5. You can now press
3
(Stop Print) at any
time to cancel the screen printing.