Fluke 867B - Save;Print Softkeys

Using the Hardkeys
Save/Print Softkeys
4
4-3
Save/Print Softkeys
Softkeys accessed by pressing
P
are:
Save
>
Screen
>
Recall Print
Save
>
Config. Exit
1
(Save Screen) accesses the Save Screen
softkeys, which allow you to save the present display
to a memory location. (Model 867B only.)
2
(Recall) accesses the Recall softkeys, which
allow you to display the contents of a memory
location.
3
(Print) prints the display. “Freeze” changes to
“Printing”, then reverts to “Freeze” when printing is
complete. You can stop printing by pressing
3
(Stop Print) or
5
(Exit); all other key presses are
ignored.
4
(Save Config.) accesses the Save Config
softkeys.
5
(Exit) returns to the original display. You can
also press
P
again to return to the original
display. You must press one of these two keys to
return; other keys do not operate during the Freeze
display.
Press
P
to stop waveform and numerical value
updates. Display contrast is reversed, the “Freeze”
message appears, and the Save/Print Softkeys are
accessed. You can now Print display information or
Save and Recall display and configuration
information.
“Enable RS232” in TrendGraph
™
Mode is canceled.
Touch Hold, Min Max, Trend, and “Peak Hold”
continue to update in the background (beeps
continue).
Refer to Chapter 6 for a full description of saving and
recalling operations available with Freeze.