Using Memory & Communications Features (Model 89)
Clearing Memory
4
4-5
Clearing Memory
You can clear memory in two ways.
• First, If the rotary switch is in the VIEW MEM position,
you can press the blue button (%) to activate the
CLEAR MEM function. CLr.? appears in the display.
You are then prompted to press [ (YES) to clear
the type of memory presently in use or ] (NO) to
stop the clear procedure. The display defines the type
of memory to be cleared, as:
; to clear logged readings memory.
MEM to clear saved readings memory.
• A second clearing procedure is required when you try
to start logging and the logged readings memory is
not empty.
CLr.? appears in the display. To clear the logged
readings memory and begin logging new data, Press
[ (YES).
To decline the clearing operation and abort new
logging, press ] (NO).
If you attempt to save a meter reading when saved
readings memory is full, FULL appears in the display. You
must use the VIEW MEM function to clear saved readings
memory before proceeding.
Using Communications
When using a PC-to-meter IR (infrared) communication
link, refer to the
FlukeView
Forms Installation Guide
or the
on-line help.
You can use the IR communication link and
FlukeView
Forms
software to transfer the contents of meter’s
memory to a PC.
FlukeView Forms
allows you to place the data into
standard (default) or customized forms. The forms can
display the data in table and graph form, as well as view
user comments. You can use these forms to satisfy ISO-
9000 documentation requirements.
To Next Page
Loading...
