Changing the Default Settings
Setting the 24-Hour Clock
5
5-7
Setting the 24-Hour Clock
The meter uses 24-hour clock readings as time stamps
during HOLD, AutoHOLD, MIN MAX, FAST MN MX,
SAVE, and LOGGING operations.
Hours and minutes to a maximum of 23:59 can be set.
Note
If the reading occurs within 1 hour of the start of
the operation, the elapsed time clock is used.
The meter also uses elapsed time for all average
readings. Elapsed time is expressed in minutes
and seconds to a maximum of 59:59.
To change the 24-hour clock:
1. Press O T until Hour appears in the display and
the hour digits in the lower right corner of the display
begin flashing.
2. Press [ or ] to increase or decrease the
hour value.
3. Press % ( s) to advance to the minute setting; the
minute digits begin flashing.
4. Press [ or ] to increase or decrease the
minute value.
5. Press O T to store the selection and proceed to
the next selection.
Setting the Line (Main) Frequency
Although the meter operates on battery power only, it is
important to specify the frequency (50 or 60 Hz) of the line
(main) power. This allows the meter to filter out related
noise.
To change the line (main) frequency:
1. Press O T until 50-60 appears in the display.
2. Press T or % to change the selection to the correct
frequency.
3. Press O T to store the selection and proceed to
the next selection.
To Next Page
Loading...
