Fluke 8845A - Configure Command Summary

8845A/8846A
Programmers Manual
28
Table 9. CONFigure Command Summary
Command Description
CONFigure[:SCALar]
[:VOLTage]
[:DC [{range}[, {resolution}]]]
:AC [{range}[, {resolution}]]
:CURRent
[:DC[ {range}][, {resolution}]]]
:AC [{range}][, {resolution}]]
:RESistance [{range}[, {resolution}]]
:FRESistance [{range}[, {resolution}]]
:FREQuency [{range}[, {resolution}]]
:PERiod [{range}[, {resolution}]]
:CAPacitance [{range}[, {resolution}]]
:TEMPerature:FRTD [{<RTD Type>}]
:TEMPerature:RTD [{<RTD Type>}]
:CONTinuity
:DIODe [{low current}][, {high voltage}]]
CONFigure?
Subsystem to set Meter function
Path to set voltage function
Selects dc volts function
Selects ac volts function
Path to set current function
Selects dc current function
Selects ac current function
Selects resistance function
Selects 4-wire resistance function
Selects frequency function
Selects period function
Selects capacitance function
Selects 4-wire temperature function
Selects 2-wire temperature function
Selects continuity function
Selects diode function
Retrieves present Meter configuration
Table 10. IEEE 488.2 Common Command Summary
Command Description
*CLS
*ESE <enable value>
*ESE?
*ESR?
*IDN?
*OPC
*OPC?
*PSC {0|1}
*PSC?
*RST
*SRE <enable value>
*SRE?
*STB?
*TST
*TRG
Clear status byte summary, and all event registers
Enable bits in standard event register
Retrieve standard event enable register
Retrieve standard event register
Retrieve meter’s identification string
Set ‘Operation Complete” bit in Standard event reg.
Returns “1” in output buffer after command
execution.
Power-on status clear
Retrieve power-on status clear setting
Reset Meter to its power-on state
Enable bits in status byte register
Retrieve bits in status byte register
Retrieve the status byte summary register
Perform self-test. Returns “0” if the test succeeds,
“1” if the test fails.
Trigger a measurement