Fluke 8845A - System and Status Management

Digital Multimeter
Supported SCPI Commands
29
Table 11. Math Command Summary
Command Description
CALCulate
:AVERage
:MINimum?
:MAXimum?
:AVERage?
:COUNt?
:DB
:REFerence
{<value>|MINimum|MAXimum}
:REFerence?
:DBM
:REFerence
{<value>|MINimum|MAXimum}
:REFerence?
:FUNCtion
{NULL|DB|DBM|AVERage|LIMIt}
:FUNCtion?
:KMATh
:STATe { on|off}
:MMFactor{<value>}
:MMFactor?
:MBFactor{<value>}
:MBFactor?
:MUNits{<name>}
:MUNits?
:LIMit
:LOWer{<value>|MINimum|MAXimum}
:LOWer?
:UPPer{<value>|MINimum|MAXimum}
:UPPer?
:NULL
:OFFSet {<value>|MINimum|MAXimum}
:OFFSet? [MINimum|MAXimum]
:STATe {ON|OFF}
:STATe?
DATA
:FEED RDG_STORE, {“CALCulate”|” ”}
:FEED?
Path to the math functions
Path to MIN-MAX function
Retrieves the recorded minimum value
Retrieves the recorded maximum value
Retrieves the recorded average value
Retrieves the number of readings during MIN-MAX run
Path to DB function
Store relative value in relative register
Retrieves the relative value from the relative register
Path to DBM function
Select dBm reference value
Retrieves the present dBm reference value
Sets the math function
Retrieves the present math function
Path to math functions
Disables/enables mx+b calculations
Sets the value of “m” for mx+b
Reads the value of “m” for mx+b
Sets the value of “b” for mx+b
Reads the value of “b” for mx+b
Sets the units name for mx+b
Reads the units name for mx+b
Path to limit testing function
Set the lower limit for limit testing
Retrieves the lower limit
Set the upper limit for limit testing
Retrieves the upper limit
Path to null function
Sets the offset value
Retrieves set or maximum or minimum offset value.
Disable/enable selected math function
Retrieves the state of the math function
Path to storing readings taken with INITiate command
Enables/disables storing of INITiate readings
Retrieves state of storing INITiate readings
Table 12. MEASure Command Summary
Command Description
MEASure[:SCALar]
:CAPacitance?
[{<range>|MIN|MAX|DEF}[{,<resolution>|MIN|MAX|DEF}]]
:CONTinuity?
:CURRent
:DC?
[{<range>|MIN|MAX|DEF}[, {<resolution>|MIN|MAX|DEF}]]
:AC?
Path to measure control
Preset and make capacitance
measurement
Make a continuity measurement
Path to measure current
Make a dc current measurement
Make an ac current measurement