Setting Up the Test Tool
17
Checking the Memory
To check the available memory space, turn the rotary
switch to AUTOTEST; then press $ Memory.
Formatting the Memory Card (DSP-4100/4300)
Autotest results you save on a DSP-4100 or DSP-4300
test tool are stored on a removable memory card. To
format a memory card, insert the card into the test tool,
select Memory Card Configuration from the
SPECIAL FUNCTIONS menu; then press $ Format.
Setting Up Cable IDs
The cable identification (cable ID) is the name you assign
to the Autotest results saved for a cable. You can create
a cable ID each time you save an Autotest, or you can
use IDs generated as follows:
Auto Increment
The auto increment function generates IDs by
incrementing the last alphanumeric character in the cable
ID. To enable this function, select Enable under
AUTO INCREMENT in SETUP.
The last character of the cable ID you enter when you
save the next Autotest will be incremented when you
save subsequent Autotests.
Auto Sequence
The auto sequence function increments letters and
numbers starting with the farthest right character, then
moving left. Special characters (such as -, #, and spaces)
and matching characters are not incremented.
To enable this function, select Sequence under
AUTO INCREMENT in SETUP. Press !
Edit ID Seq. to enter a start and end ID for the
sequence. When you save an Autotest, the test tool
displays the ID list. Used IDs are preceded by a “$”.
To Next Page
Loading...
Need help?
General
