Saving Autotest Results
19
Saving Autotest Results
To save the Autotest results, press S. Depending on
which cable ID function is enabled in SETUP, you can
either create a cable ID or select an ID from a pre-
configured list. Press S again after creating or
selecting an ID.
DSP-4000
A DSP-4000 test tool can store the results of 500 or more
Autotests, depending on the test standard used. Results
are stored in text-based format.
DSP-4100/4300
A DSP-4100 or DSP-4300 test tool with STORE PLOT
DATA enabled can store at least 250 Autotests in
graphical format on a 16 MB memory card, depending on
the standard used.
If no memory card is present in a DSP-4300 test tool, test
results are saved to internal memory. Later, when you
insert a memory card, the test tool lets you choose
whether or not to copy the saved results from internal
memory to the memory card.
Note for Model DSP-4300
To avoid confusion regarding the contents of the
internal memory, save test results on a
removable memory card whenever possible.
Calibrating the Test Tool
To ensure maximum accuracy of test results, perform the
self-calibration every 30 days. Select Self
Calibration from the SPECIAL FUNCTIONS menu.
See Chapter 6 of the Users Manual for details.
Fluke Networks recommends factory calibration once a
year to ensure that the test tool meets or exceeds the
published accuracy specifications. To return a unit to
Fluke Networks for calibration, call an authorized Fluke
Networks Service Center for return instructions.
Getting Software Upgrades
Keeping your test tool’s software current gives you
access to new features and the latest test standards.
Software upgrades are available for free on the Fluke
Networks website. See the online documentation in
LinkWare for information on installing upgrades.
To Next Page
Loading...
Need help?
General
