23
Rear Panel Features
The following list provides descriptions of the
connectors and switches on the Calibrator’s rear
panel.
Rear Panel Connectors
5725A AMPLIFIER Connector
Provides the analog and digital interface for the
Fluke 5725A Amplifier.
5205A AMPLIFIER Connector
Provides the analog and control interface for either
the Fluke 5205A or 5215A Precision Power
Amplifier.
5220A AMPLIFIER Connector
Provides the analog and control interface for the
Fluke 5220A Transconductance Amplifier.
VARIABLE PHASE OUT BNC Connector
Provides access to a variable-phase nominal 2.5V
rms sine wave signal. The phase of this signal can
be adjusted using the arrow keys and rotary knob
(or by remote commands) to lead or lag the main
Calibrator output signal by up to 180°. The
connector shell is not connected directly to chassis
ground; it is connected internally to the OUTPUT
LO binding post. The maximum allowable potential
between the connector shell and chassis ground is
20V peak.
To Next Page
Loading...
Need help?
General
