1
Contents
What is in this Guide? ................................ 2
Safety Summary......................................... 2
P Fuse and Line Voltage .......................... 4
Basic Operation.......................................... 5
A Short Calibration Exercise....................... 5
Warming up the Calibrator ..................... 5
Exercise: Running dc Zero Calibration........ 6
Connecting a Meter................................ 6
Applying a dc Voltage ............................ 7
Checking the Calibrator Uncertainty ....... 7
Exercise: Activating Error Mode ............. 8
Checking the Meter’s Higher and Lower
Ranges..................................... 8
Exercise: Applying an ac Voltage ........... 9
Front Panel Features.................................. 10
Output Display (Left Side)...................... 10
Control Display (Right Side)................... 10
Display Screen Saver............................. 11
Front Panel Keys ................................... 12
Front Panel Connectors ......................... 21
Rear Panel Features .................................. 23
Rear Panel Connectors.......................... 23
Switches and Fuse Holder...................... 26
Cable Recommendations............................ 27
Connecting to a UUT (Unit Under Test) ...... 28
Using Error Mode....................................... 35
Operating in Remote .................................. 37
RS-232-C Interface Parameters.................. 38
To Next Page
Loading...
