36
Using Error Mode (cont.)
Keys Action
E Returns to the previous reference
value.
+, then E Establishes a new reference.
A keypad entry, then
E
Establishes a new reference.
N Establishes the present output as a
new reference.
Y Sets the Calibrator to ten times the
reference value and establishes a new
reference.
Z Sets the Calibrator to one-tenth the
reference value and establishes a new
reference.
o Identifies the present output as a zero-
scale endpoint for scaling, and
establishes 0.0 as the new reference.
S Identifies the present output as a full-
scale endpoint for scaling and causes
the display to show scale error.
r Returns to the power-up state.
The “Setup Menus”
softkey
Opens the setup menu.
To Next Page
Loading...
