Fluke LinkRunner Pro User Manual

Reports Edit/Erase
Allows you to edit report names and erase reports. Each report contains a
summary of the Home screen, PING screen, and LLDP, EDP, CDP screen. The
reports must be viewed on the LinkRunner Connect PC application.
Selecting the report name/number to edit: When is highlighted, press the
selection button (center). Use the up/down arrow keys to choose the report
number and the selection button to select it. Notice at the bottom of the
display, the report name changes as you scroll thru the report numbers. By
default the names are Report01 – Report04.
Editing the report name: Using the down arrow key, move down to the report
name. Press the selection button (center). To edit the report name, move right
to each character (by using the right arrow key) and use the up/down arrow
keys to select each character value. Keep doing this until the report name is
entered, then press the selection button.
Erasing a report: Using the down arrow key, move down to erase the report.
Press the selection button (center) and the report is erased. Erased or empty
reports have no lines in the symbol.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Fluke LinkRunner Pro Specifications

Operating Environment

operating temperature	10 – 40 degrees C
storage temperature	-20 to 60 degrees C
operating humidity	95% relative humidity (non-condensing)

Power

battery type	4 AA batteries
RJ-45 network port maximum voltage	100 V
tone generator digital tone frequency	500 KHz

Weight and Dimensions

weight with 4 AA Alkaline batteries	10 oz
weight with 4 AA LI batteries	8.4 oz
height	5.3 inches
width	3.1 inches
depth	1.3 inches