Need help?Do you have a question about the Fluke LinkRunner AT 1000 and is the answer not in the manual?
General| Model | LinkRunner AT 1000 |
|---|---|
| Display | Color LCD |
| Battery | Rechargeable Lithium-ion |
| Connectivity | Ethernet, Wi-Fi |
| Network Discovery | Yes |
| Humidity | 10% to 90% non-condensing |
| Type | Network Tester |
| Protocols Supported | IPv4, IPv6 |
| Cable Tests | Wiremap, length, distance to fault |
| Connectivity Tests | Ping |
| PoE Verification | Yes |
| Supported Standards | IEEE 802.3, IEEE 802.3u, IEEE 802.3ab |
| Interfaces | Ethernet port, USB |
| Operating Temperature | 0 to 50 °C |
| Storage Temperature | -20 to 60 °C |
| Safety Compliance | CE |
Provides access to product updates, troubleshooting, and services via the website.
Offers answers to common questions and information on network/cable testing procedures.
Details safety symbols used on the tester and in the manual, with explanations.
Provides instructions on cleaning the display and case using appropriate materials.
Details the function of each numbered key, port, and indicator on the LinkRunner AT tester.
Explains indicators for battery, AC/USB connection, link status, speed, duplex, and connection types.
Describes icons for Switch, Cable, AutoTest, and Tools for accessing device functions and profiles.
Provides step-by-step instructions and illustrations for replacing the device's battery pack.
Covers testing RJ45 cable quality, fiber signal strength, and cable tracing.
Addresses verifying network connectivity, DHCP/IPv6, and PoE support.
Explains application connectivity, throughput testing, and 802.1X port access.
Details steps to save measurement data into a report file, name, and overwrite reports.
Configures IP address, subnet mask, gateway, and DNS settings for network connectivity.
Sets up VLAN/MAC addresses and network connection parameters like 802.1X and speed/duplex.
Configures AutoTest targets and PoE settings, including TruePower testing.
Manages profiles/reports, restores defaults, and updates firmware for the device.
Covers transferring/managing profiles, setting language, and using AutoTest, Switch, and Cable tests.
To Next Page
