LinkRunner AT 1000/2000 Network Auto-Tester
Users Manual
8
Common Questions LR-AT Can Solve
First connect an RJ-45 or fiber cable (2000 model only) from
the network hub or wall plate to the LinkRunner AT RJ-45
LAN or fiber port. Check the following list of questions and
associated answers to see how LinkRunner AT can help you
get the job done.
Common Questions
Q > Is this a good RJ45 Ethernet cable?
A > Use Cable testing and the built in wiremap for patch
cables, or an external Wireview
TM
Office Locator.
Q > Am I receiving a good fiber signal?
A > Connect to your network via a SFP adapter and
validate the signal strength and link in the Switch
screen.
Q >Where does this RJ45 cable go?
A >Use the Cable test toner function, Switch > Flash
Port function, or Switch discovery protocol.
Q > Is this cable hooked up to anything?
A > Select Switch to identify an open cable, an active
link, an un-powered network device or telephone
voltage.
Q > Does this RJ45 drop support PoE?
A > Use Tools to specify the desired PoE power class and
use Switch or AutoTest to verify the power under load
up to 25.5W (802.3at).
Q > What speed/duplex is this device configured for?
A > Use Switch to check the advertised and actual
speed/duplex. Additionally, use Tools to tests for manual
(non-Auto Negotiated) speed/duplex.
Q > Can I see traffic from this connection?
A > Observe the utilization LED blinking to see network
traffic.
To Next Page
Loading...
Need help?
General
