Set Up the Tester
15
Select Configure.
ffy33.bmp
Figure 12. Reflector Default Configuration Screen
The LR-AT 2000 must to be configured to:
MAC + Fluke - This filter setting allows the LR-AT 2000 to
only reflect packets when the destination MAC address
field matches the LR-AT 2000's own MAC address and Fluke
payload.
MAC + IP - This swap setting allows the LR-AT 2000 to swap
the source and destination MAC and IP addresses for
packets that are reflected back to the analyzer.
Note
Any other Reflector setting may cause undesired
traf
fic on your network.
LinkRunner Information
Select Tools > LinkRunner Information.
This screen displays the following LR-AT product
information:
Serial Number: The serial number is also shown under
the battery pack.
MAC Address: Media Access Control address. The
unique address of the tester.
SW Version: The version of software in the tester.
Build: The build number of the software version.
Note
An SFP SX fiber adapter was connected to the tester
in figure 13.
To Next Page
Loading...
Need help?
General
