Fluke ScopeMeter 190 II Series - Page 257

Calibration Adjustment
Final Calibration (Firmware: V10.9 and Lower) 

 Warning
To prevent possible electrical shock, fire, or personal injury,
ensure that the calibrator is in standby mode before making any
connection between the calibrator and the Test Tool.
Dangerous voltages are present on the calibration source and
connection cables during these steps.
 6HWWKH$WRRSHUDWH235
 3UHVV
F3
WRVWDUWWKHFDOLEUDWLRQ
 :DLWXQWLOWKHGLVSOD\VKRZVFDOLEUDWLRQVWDWXV
:READY
 3UHVV
F2
WRVHOHFWWKHQH[WFDOLEUDWLRQVWHSVHWWKH$WRWKHQH[W
FDOLEUDWLRQSRLQWDQGVWDUWWKHFDOLEUDWLRQ&RQWLQXHWKURXJKDOOFDOLEUDWLRQ
SRLQWVRI7DEOH
 6HWWKH$WR6WDQGE\DQGFRQWLQXHDWWKHInput ABCD (AB) Position
VHFWLRQ
Table 5-17. Input ABCD Gain Calibration Points
Cal step UUT input value (5502A SCOPE, MODE volt, SCOPE Z 1 M
7
, 1 kHz)
&/ P9
&/ P9
&/ QRQH VWDQGE\
&/ P9
&/ QRQH VWDQGE\
&/ P9
&/ P9
&/ P9
&/ P9
&/ QRQH VWDQGE\
&/ 9
&/ 9
&/ 9
&/ 9
&/ 9
&/ 9
&/ 9
&/ 9 VHW$WR235