Fluke ScopeMeter 190 II Series - Page 258

Fluke 190-062, -102, -104, -202, -204, -502, -504
Service Manual

Input ABCD (AB) Position
7RGRWKH,QSXW$%&'$%3RVLWLRQFDOLEUDWLRQ
 3UHVV
F2
WRVHOHFWFDOLEUDWLRQDGMXVWPHQWVWHSCL 0619.
 5HPRYHDOO,QSXW$%&'$%FRQQHFWLRQVRSHQLQSXWV
 3UHVV
F3
WRVWDUWWKHFDOLEUDWLRQ
 :DLWXQWLOWKHGLVSOD\VKRZVFDOLEUDWLRQVWDWXV
:READY
 &RQWLQXHDWWKHInput ABCD (AB) Volt Gain VHFWLRQ
Input ABCD (AB) Volt Gain
 Warning
To prevent possible electrical shock, fire, or personal injury,
ensure that the calibrator is in standby mode before making any
connection between the calibrator and the Test Tool.
Dangerous voltages are present on the calibration source and
connection cables during these steps.
Note
The adjustment steps for channel C and D are only for the models
190-104 and 190-204.
7RGRWKH,QSXW$%&'$%9ROW*DLQFDOLEUDWLRQ
 3UHVV
F2
WRVHOHFWWKHILUVWFDOLEUDWLRQVWHSLQ7DEOH
 &RQQHFWWKH7HVW7RROWRWKH$DVVKRZQLQ)LJXUH
NORMAL SCOPE
FLUKE 5502A CALIBRATOR
PM9091
PM9081
CONNECT TO CHANNEL A, B, C, D IN PARALLEL
50 OHM TERMINATIONNO
ADC
B
PM9093
PM9092
AB
METER
P
M
9
0
9
3
PM9092
2 CHANN. + METER
4 CHANNELS
Figure 5-16. Test Tool Input ABCD to 5502A Normal Output
 6HWWKH$WRVXSSO\D'&YROWDJH1250$/RXWSXWWRWKHILUVW
FDOLEUDWLRQSRLQWLQ7DEOH
 6HWWKH$WRRSHUDWH235
 3UHVV
F3
WRVWDUWWKHFDOLEUDWLRQ
 :DLWXQWLOWKHGLVSOD\VKRZVFDOLEUDWLRQVWDWXV
:READY