Fluke SMFT1000/PRO - Select PV Model; Paired with Irradiance Meter Only

SMFT-1000
Users Manual
22
Select PV Model
When the Irradiance Meter is not connected, no limits are available and no irradiance or
temperature data shows on the display.
To take a measurement:
1. Connect the test leads from the PV Analyzer to the solar panel.
Tip: Push
 to see a connection diagram.
The V
OC
measurement shows on the display after you connect the test leads. The Pass/Fail
icons do not show in this configuration.
2. Push
 to start the I
SC
measurement.
The V
OC
and I
SC
results show on the display.
3. Push
 to save the results to memory.
A confirmation message with ID number shows on the display and then returns to the test
screen.
Paired with Irradiance Meter Only
When the Irradiance Meter is connected and a PV model is not selected, no limits are available.
The irradiance and temperature data from the Irradiance Meter shows on the display.
To take a measurement:
1. Connect the test leads from the PV Analyzer to the solar panel. The V
OC
measurement
automatically shows on the display.
Tip: Push
 to see a connection diagram.
The V
OC
measurement shows on the display after you connect the test leads. Irr & Tcell
data from the Irradiance Meter shows on the display. The Pass/Fail icons do not show in
this configuration.
2. Push
 to start the I
SC
measurement.
The V
OC
and I
SC
results show on the display.
3. Push
 to save the results to memory.
A confirmation message with ID number shows on the display and then returns to the test
screen.