SMFT-1000
Users Manual
42
Periodically wipe the case with a damp cloth and mild detergent. Do not use abrasives or
solvents. Dirt or moisture in the terminals can affect readings.
To clean the terminals:
1. Turn off the PV Analyzer and remove all test leads.
2. Shake out any dirt that may be in the terminals.
3. Moisten a clean cotton swab with alcohol and clean the inside of each terminal.
Ta b l e 8 is a list of replaceable parts for the Tester.
Fuse Replacement
To replace the fuse (see Figure 3):
1. Push
to turn off the PV Analyzer.
2. Remove the test leads from the terminals.
3. To remove the battery door, use a standard-blade screwdriver to turn the battery door
screws (x3) one-quarter turn counterclockwise.
4. Replace the fuse.
5. Replace the battery door.
6. Turn the battery door screws one-quarter turn clockwise to fasten the door.
7. The battery voltage shows in the secondary display.
Warning
To prevent possible electric shock or personal injury due to false readings:
Replace the batteries as soon as the empty battery icon appears.
Be sure that the battery polarity is correct. A reversed battery can cause leakage.
Table 8. Replacement Parts
Description Part Number
Fuse, FF 630 mA 1000 V IR 30 kA for PV Analyzer 5335526
Battery Holder 1676850
Battery Access Door 5330087
To Next Page
Loading...
