1
T3
Introduction
This calibration information sheet provides the following information for the T3 Tester (hereafter
referred to as "the tester"):
• Safety information
• Parts and service information
• Specifications
• Cleaning procedure
• Required equipment
• Performance tests
• Calibration adjustment
• Battery replacement procedure
• Parts and accessories list
For operating instructions, refer to the T3 Tester Instruction Sheet.
Definition Symbols Used in this Manual
Table 1. Symbols
B
AC (alternating current)
X
Hazardous Voltage
F
DC (direct current)
T
Double insulated
W
Important information
P
Conforms to European Union
Directives
On light
R
Beeper
J
Earth ground Underwriters Laboratories
Certification
Conforms to CSA C22.2 No 1010-1-92 + Amendment 2 1997
N10140
Conforms to relevant Australian standards
To Next Page
Loading...
Need help?
General
