Thermal Imagers
Maintenance
43
W Caution
To prevent damage, do not expose Product to heat
sources or high-temperature environments such as an
unattended vehicle in the sun.
To get the best performance from the lithium-ion battery, use the guidelines
that follow:
• Do not store the Imager on the charger for more than 24 hours as reduced
battery life may result.
• Charge the Imager for a two-hour minimum at six-month intervals for
maximum battery life. Without use, the battery will self-discharge in
approximately six months. Batteries stored for long periods will need two
to ten charging cycles for full capacity.
• Always operate in the specified temperature range.
~ W Caution
Do not incinerate the Product and/or battery. Go to Fluke’s
website for recycling information.
To Next Page
Loading...
