TS
®
44 PRO Test Set Users Card
Redial the Last Number Dialed
Go off-hook and press the LNR key.
Pulse Dialing
By default the unit is configured to Tone dial. But if
you want to Pulse dial, go off-hook and press the
TONE/PULSE key, now the unit will pulse dial.
Program Speed Dial Numbers
In Monitor mode, press RCL. Enter the number to
be stored. Press STORE/PROG, then press the num-
ber of the memory location (0-9) where you want
to store it. The confirmation tone sounds.
To Speed Dial a Stored Number
Go off-hook, press RCL, then press the key (0-9) of
the memory location where the number is stored.
Two-Way Speakerphone
While off-hook, press SPKR to activate. Press SPKR
again to deactivate. If you are listening only, press
MUTE to activate the Receive-Only Loud Speaker.
Press MUTE again to restore the two-way Speaker-
phone.
To Set Receive-Only Loud Speaker as
Default
1 Put the test set in Monitor mode.
2 Press STORE/PROG.
3 Press MUTE. The confirmation tone sounds.
To restore the Speakerphone as the default
Speaker mode, repeat the three steps above.
To Previous Page
Loading...
