Face up,do not invert
If you want to use it under server cold condition, please do the insulation work.
It is recommended to install as close to the vibration as possible, parallel to the fuselage
The FC system is not waterproof, oil-proof, or dust-proof.
Check frequently to ensure that the double-sided tape is securely installed.
FC System Connection
Follow the instructions below to complete the connection，And use a plastic cable tie
to organize the connection to make it clean.
H1 is the metal shell, do not take the power to H1 or the carbon plate of H1
Aircraft equipment connection
When using H1, it is necessary to connect the receiver, ESC, battery and other related
aircraft equipment, and set their parameters in H1-Heli, otherwise it may not be able to
fly or even cause serious safety accidents.
Receiver
Different types of receiver connection interfaces are different, please connect
accordingly. After the connection is successful, the FC will automatically recognize the
signal and display the stick information on the software.
To Next Page
Loading...
